Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › EFI RELAY

EFI RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE EFI RELAY


A126393E03
  1. Remove the relay block cover upper.

  1. Remove the EFI relay.



3. INSPECT EFI RELAY


A126370
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      Below 1 Ω
      (Battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the EFI relay.



4. INSTALL EFI RELAY
  1. Install the EFI relay.

  1. Install the relay block cover upper.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }