Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › CIRCUIT OPENING RELAY

CIRCUIT OPENING RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE CIRCUIT OPENING RELAY


A126393E02
  1. Remove the relay block cover upper.

  1. Remove the circuit opening relay.



3. INSPECT CIRCUIT OPENING RELAY


A126370
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      Below 1 Ω
      (Battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the circuit opening relay.



4. INSTALL CIRCUIT OPENING RELAY
  1. Install the circuit opening relay.

  1. Install the relay block cover upper.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }