Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › A/F SENSOR HEATER RELAY

A/F SENSOR HEATER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE AIR FUEL RATIO SENSOR HEATER RELAY


    A224268E01
  1. Remove the upper relay block cover.

  1. Remove the air fuel ratio sensor heater relay.
    Text in Illustration 
    *1
    Air Fuel Ratio Sensor Heater Relay



2. INSPECT AIR FUEL RATIO SENSOR HEATER RELAY


A126371
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 4
      Battery voltage not applied
      Below 1 Ω
      Battery voltage applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the air fuel ratio sensor heater relay.



3. INSTALL AIR FUEL RATIO SENSOR HEATER RELAY
  1. Install the air fuel ratio sensor heater relay.

  1. Install the upper relay block cover.