Home › BODY › SEAT › REAR SEAT ASSEMBLY (for LH Side)

REAR SEAT ASSEMBLY (for LH Side) > DISASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE REAR SEAT CUSHION HINGE SUB-ASSEMBLY


B267732

HINT:
Use the same procedure for both sides.

  1. Remove the bolt.

  1. Disengage the hook and remove the rear seat cushion hinge.



2. REMOVE REAR SEAT CUSHION UNDER COVER


    B130724E02
  1. Remove the rear seat cushion stopper from the rear seat cushion cover band and the slit of the rear seat cushion under cover.
    Text in Illustration 
    *1
    Band

  1. Using a clip remover, remove the 5 clips and the rear seat cushion under cover.



3. REMOVE REAR SEAT CUSHION STOPPER


    B130725
  1. Remove the screw and the rear seat cushion stopper.



4. REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY


    B130726
  1. Disengage the hook and remove the rear seat cushion frame.



5. REMOVE REAR SEAT CUSHION COVER


    B130727
  1. Remove the 10 hog rings and the rear seat cushion cover.



6. REMOVE REAR SEAT HEADREST ASSEMBLY
  1. Push the lock button of the rear seat headrest support and remove the rear seat headrest.



7. REMOVE REAR SEAT HEADREST HANDLE


    B271551E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the snap ring and remove the rear seat headrest handle.
    Text in Illustration 
    *1
    Protective Tape



8. REMOVE REAR SEATBACK LOCK COVER


    B271144
  1. Remove the screw.

  1. Disengage the guide and remove the rear seat back lock cover.



9. REMOVE TETHER ANCHOR COVER


    B130732E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.
    Text in Illustration 
    *1
    Protective Tape



    B130734E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the tether anchor cover.
    Text in Illustration 
    *1
    Protective Tape



10. REMOVE REAR SEAT HEADREST SUPPORT


    B130736
  1. Remove the 14 hog rings.



    B130739
  1. Disengage the 2 claws and remove the rear seat headrest support.

    HINT:
    Use the same procedure for both sides.



11. REMOVE REAR SEATBACK LOCK RELEASE BUTTON


    B130743
  1. Remove the rear seatback lock release button.



12. REMOVE REAR SEATBACK STOP BUTTON GROMMET


    B130741
  1. Disengage the 2 claws and remove the rear seatback stop button grommet.



13. REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY


    B130738
  1. Remove the rear seatback frame.



14. REMOVE REAR SEATBACK LOCK ASSEMBLY


    B130742
  1. Remove the 2 bolts and the rear seatback lock.



15. REMOVE REAR SEATBACK COVER


    B130744
  1. Pass the hook of the rear seatback cover through the slit in the rear seatback pad.

  1. Remove the 8 hog rings and the rear seatback cover.