Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE ACCESS PANEL REAR WEATHERSTRIP


B135524
  1. Remove the access panel rear weatherstrip.



3. REMOVE LAP BELT OUTER ANCHOR COVER


B357293
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



4. REMOVE ACCESS DOOR INSIDE HANDLE SUB-ASSEMBLY


B135527
  1. Insert a clip remover between the rear door inside handle sub-assembly and rear door trim board sub-assembly.

  1. Turn the rear door inside handle sub-assembly with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door inside handle sub-assembly and snap ring.



5. REMOVE CUP HOLDER


B135528
  1. Remove the screw and No. 1 cup holder.



6. REMOVE ACCESS DOOR TRIM BOARD SUB-ASSEMBLY


    B357499
  1. Disengage the 9 clips and remove the rear door trim board sub-assembly.



7. REMOVE CENTER PILLAR UPPER GARNISH


B356724
  1. Remove the clip.

  1. Remove the 2 screws.

  1. Disengage the 2 clips.

  1. Pass the floor anchor of the front seat outer belt assembly through the center pillar upper garnish and remove the center pillar upper garnish.



8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B135087
  1. Remove the nut and the through anchor.



    B267694E01
  1. Using a screwdriver, release the locking button of the pretensioner connector.
    Text in Illustration 
    *1
    Locking Button

  1. Using a screwdriver, disconnect the pretensioner connector.



    B267696
  1. Remove the 2 bolts, the 2 hooks and the retractor.



9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B268841
  1. Remove the 2 bolts, the hook and the shoulder belt anchor adjuster.