Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


    B268600E01
  1. Check the resistance.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Front Seat Inner Belt (Driver Side))

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Tongue plate fastened
      10 kΩ or higher
      Tongue plate released
      Below 1 Ω

      If the result is not as specified, replace the front seat inner belt.