Home › BODY ELECTRICAL › AUDIO / VISUAL › LUGGAGE SPEAKER

LUGGAGE SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR SPEAKER ASSEMBLY


E197034E03

HINT:
Remove interior parts so that the rear speaker can be seen.

Text in Illustration 
*a
Component without harness connected
(Rear Speaker Assembly)
  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the rear speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the rear speaker.

  1. Check the resistance.

    1. Disconnect the speaker connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      Approximately 1.9 Ω

      If the result is not as specified, replace the rear speaker.