Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA POLE

RADIO ANTENNA POLE > INSTALLATION

for Preparation Click here



1. INSTALL RADIO ANTENNA POLE SUB-ASSEMBLY


    E148353E01
  1. Install the radio antenna pole sub-assembly by hand until fully seated.
    Text in Illustration 
    *a
    1/8 turn (20 to 45 degrees)

  1. Using a 8 mm (5/16 inch) wrench, fully tighten the radio antenna pole about 1/8 turn (20 to 45 degrees) by turning it clockwise.

    NOTICE:
    1. Do not over tighten. Tighten with finger, not hand.
    2. Do not use pliers to tighten the radio antenna pole as it can leave marks on the radio antenna pole surface.
    3. The antenna pole cannot be hand tightened to the proper specification.

    Torque:
    3.3 N*m{ 34 kgf*cm , 29 in.*lbf }