Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL


B135557
  1. Disengage the 3 claws and the clip.

  1. Disconnect the all connectors and remove the front armrest base upper panel.



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B331550E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and open the 2 covers.
    Text in Illustration 
    *1
    Protective Tape



    B331551
  1. Remove the 2 screws.

  1. Remove the clip.

  1. Disengage the 10 clips.



    B135572
  1. Disconnect the front door lock remote control cable and the front door inside locking cable and remove the front door trim board sub-assembly.



4. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    B130580
  1. Disconnect the speaker connector.



    B130581
  1. Remove the 4 screws and the front No. 1 speaker.