Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY


B130579E02

HINT:
Remove interior parts so that the front No. 1 speaker can be seen.

Text in Illustration 
*1
Ohmmeter
*a
Component without harness connected
(Front No. 1 Speaker Assembly)
  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the front No. 1 speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the front No. 1 speaker.

  1. Check the resistance.

    1. Disconnect the speaker connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (except 10 Speakers):
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      Approximately 4 Ω

      Standard Resistance (for 10 Speakers):
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      Approximately 1.8 Ω

      If the result is not as specified, replace the front No. 1 speaker.