Home › ENGINE › 1GR-FE EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector.



    A229665E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



2. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
  1. Disconnect the sensor connector.



    A223689E02
  1. Using SST, remove the sensor.

    SST
    09224-00010  



3. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A129936
  1. Remove the 2 bolts and separate the exhaust pipe support, then remove the tail exhaust pipe.



4. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A129937
  1. Remove the 2 bolts and 2 compression springs, then separate the center exhaust pipe.

  1. Separate the 4 exhaust pipe supports from the center exhaust pipe, then remove the center exhaust pipe.



5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    A129939
  1. Remove the 2 bolts, then remove the exhaust pipe stopper bracket. (for 4WD)



    A129938
  1. Remove the 2 bolts and 2 nuts and separate the exhaust pipe support, then remove the front No. 2 exhaust pipe.



6. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A128851
  1. Remove the 2 nuts, then remove the front exhaust pipe.

  1. Remove the front exhaust pipe gasket.