Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 8 FLOOR WIRE (w/ Back Sonar)


B271012
  1. Disconnect the 2 connectors.

  1. Disengage the 7 clamps and remove the floor wire.



2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Back Sonar)


    E185144
  1. Disengage the 2 claws and remove the ultrasonic sensor.

    HINT:
    Use the same procedure for the remaining parts.



3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Back Sonar)


    E185146
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer.

    HINT:
    Use the same procedure for the remaining parts.



4. REMOVE REAR BUMPER PAD LH


    B135148
  1. Remove the 5 retainers.

  1. Disengage the 5 claws and remove the rear bumper pad.



5. REMOVE REAR BUMPER PAD RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE REFLEX REFLECTOR ASSEMBLY LH


    B135149
  1. Remove the nut and the reflex reflector.



7. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



8. REMOVE REAR BUMPER LOWER COVER


    B135150
  1. Remove the 4 screws.

  1. Disengage the 4 clips and remove the rear bumper lower cover.



    B135151
  1. Remove the 4 screw grommets.