Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > REASSEMBLY

for Preparation Click here



1. INSTALL REAR BUMPER LOWER COVER


    B135151
  1. Install the 4 screw grommets.



    B135150
  1. Engage the 4 clips and install the rear bumper lower cover.

  1. Tighten the 4 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }



2. INSTALL REFLEX REFLECTOR ASSEMBLY LH


    B135149
  1. Install the reflex reflector with the nut.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }



3. INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



4. INSTALL REAR BUMPER PAD LH


    B135148
  1. Engage the 5 claws and install the rear bumper pad.

  1. Install the 5 retainers.



5. INSTALL REAR BUMPER PAD RH

HINT:
Use the same procedure as for the LH side.



6. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Back Sonar)


    E185141E01
  1. Temporarily install the ultrasonic sensor retainer to the rear bumper.
    Text in Illustration 
    *1
    Protrusion
    *2
    Keyhole

    NOTICE:
    1. Do not damage the rear bumper with the protrusion when installing the retainer.
    2. Securely install the ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.

    HINT:
    1. When installing the retainer, align the keyhole and protrusion as shown in the illustration.
    2. Use the same procedure for the remaining parts.

  1. Engage the 2 claws to install the ultrasonic sensor retainer.

    HINT:
    Use the same procedure for the remaining parts.



7. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Back Sonar)


    E185142
  1. Engage the 2 claws to install the ultrasonic sensor.

    NOTICE:
    Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

    HINT:
    Use the same procedure for the remaining parts.



8. INSTALL NO. 8 FLOOR WIRE (w/ Back Sonar)
  1. Engage the 7 clamps and install the floor wire.

  1. Connect the 2 connectors.