Home › BODY › EXTERIOR › BACK DOOR OUTSIDE GARNISH

BACK DOOR OUTSIDE GARNISH > INSTALLATION

for Preparation Click here



1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    B135114
  1. Engage the 4 clips and install the back door outside garnish.



    B135111
  1. Tighten the 2 nuts.

    Torque:
    6.0 N*m{ 60 kgf*cm , 53 in.*lbf }



    B135110
  1. Connect the back door lock rod.

  1. Connect the license light connector.



    B135109
  1. Engage the 4 claws and install the plug hole.



    B135112E01
  1. Remove the protective tape.



2. INSTALL BACK DOOR SERVICE HOLE COVER


    B135108E01
  1. Install the back door service hole cover.



3. INSTALL BACK DOOR TRIM BOARD


    B135554
  1. Engage the 16 clips and install the back door trim board.

  1. Install the 2 screws.



4. INSTALL BACK DOOR TRIM COVER RH


B139382
  1. Engage the 3 claws and back door trim cover.



5. INSTALL BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as described for the RH side.



6. INSTALL BACK DOOR OUTSIDE MOULDING


    B135032
  1. Install 6 new clips in the positions shown in the illustration.

    NOTICE:
    If you install the clips wrongly, the installation of the back door outside moulding RH will be improper.



    B135031
  1. Engage the 6 clips and install the back door outside moulding RH.

  1. Install the screw.

  1. Remove the protective tape.



7. INSTALL SPARE TIRE

Torque:
88 N*m{ 897 kgf*cm , 65 ft.*lbf }



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }