Home › BODY › EXTERIOR › FENDER PANEL MUDGUARD

FENDER PANEL MUDGUARD > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL QUARTER PANEL MUDGUARD


    B135085
  1. Align the 2 pins of the quarter panel mudguard with the installation hole of the quarter outside moulding.

  1. Install the quarter panel mudguard with the 4 screws.

    Torque:
    5.0 N*m{ 50 kgf*cm , 44 in.*lbf }

  1. Install the clip.



2. INSTALL FRONT FENDER MUDGUARD


    B135083
  1. Align the pin of the front fender mudguard with the installation hole of the front fender moulding.

  1. Install the front fender mudguard with the 5 screws.

    Torque:
    5.0 N*m{ 50 kgf*cm , 44 in.*lbf }

  1. Install the clip.



3. INSTALL REAR BUMPER COVER
  1. Engage the 6 claws and the 2 clips and install the rear bumper cover.

  1. Connect the connector.

  1. Connect the clamp and install the floor wire.

    HINT:
    If the vehicle is equipped with back sonar, connect the connector and install the floor wire.

  1. Tighten the 7 bolts and the 2 screws.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf } for bolt
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf } for screw



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Back Sonar)

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }