Home › BODY › EXTERIOR › FENDER PANEL MUDGUARD

FENDER PANEL MUDGUARD > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Back Sonar)


2. REMOVE REAR BUMPER COVER


    B135140E02
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B135141
  1. Remove the 7 bolts and the 2 screws.



    B268275
  1. Disengage the clamp and disconnect the floor wire.

  1. Disconnect the connector.

    HINT:
    If the vehicle is equipped with back sonar, disconnect the connector and floor wire.



    B135143
  1. Disengage the 6 claws and the 2 clips and remove the rear bumper cover.



3. REMOVE FRONT FENDER MUDGUARD


    B135082
  1. Using a clip remover, remove the clip.

  1. Remove the 5 screws and the front fender mudguard.



4. REMOVE QUARTER PANEL MUDGUARD


    B135084
  1. Using a clip remover, remove the clip.

  1. Remove the 4 screws and the quarter panel mudguard.