Home › BODY › EXTERIOR › FRONT DOOR GLASS WEATHERSTRIP

FRONT DOOR GLASS WEATHERSTRIP > INSTALLATION

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    B135101
  1. Engage the 8 claws and install a new front door glass outer weatherstrip.



    B135099E01
  1. Remove the protective tape.



2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    B135564
  1. Install the outer rear view mirror with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



3. INSTALL FRONT DOOR NO. 2 SERVICE HOLE COVER

HINT:
Use the same procedure as for the RH side .



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



5. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }