Home › BODY › EXTERIOR › ACCESS DOOR GLASS WEATHERSTRIP

ACCESS DOOR GLASS WEATHERSTRIP > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE ACCESS DOOR GLASS OUTER WEATHERSTRIP


    B135103E01
  1. Apply protective tape to the rear door panel in the area around the access door glass outer weatherstrip.



    B135104E01
  1. Using a moulding remover, disengage the 3 clips and remove the access door glass outer weatherstrip.