FRONT DOOR BLACK OUT TAPE > INSTALLATION |
| 1. INSTALL NO. 2 BLACK OUT TAPE |
Application precautions.
Application temperature.
Pre-application procedure.
Handling.
Application method (Method of squeegee operation and application for general portions).

![]() |
Application method (Method of squeegee operation).
Application method (Method of squeegee operation and application method for corner sections).
Inspection.
Clean the attachment surface (Using an infrared light).
Using an infrared light, heat any black out tape and adhesive remaining on the body.
Using a shop rag or piece of cloth, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Clean the attachment surface (Using a tape removal disc).
Set the 8 discs in the holder and insert the removal disc into an air drill or electric drill.
Using a tape removal disc, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Apply new No. 2 black out tape to the positions shown in the illustration.

| Mark | Measurement |
| a | 2 to 4 mm (0.079 to 0.157 in.) |
| b | 4 to 6 mm (0.157 to 0.236 in.) |
| 2. INSTALL NO. 3 BLACK OUT TAPE |
Application precautions.
Clean the attachment surface (Using an infrared light).
Clean the attachment surface (Using a tape removal disc).
Apply new No. 3 black out tape to the positions shown in the illustration.

| Mark | Measurement |
| a | 4 to 6 mm (0.157 to 0.236 in.) |
| b | 2 to 4 mm (0.079 to 0.157 in.) |
| 3. INSTALL NO. 1 BLACK OUT TAPE |
Application precautions.
Clean the attachment surface (Using an infrared light).
Clean the attachment surface (Using a tape removal disc).
Apply new No. 1 black out tape to the positions shown in the illustration.

| Mark | Measurement |
| a | 2 to 4 mm (0.079 to 0.157 in.) |
| b | 4 to 6 mm (0.157 to 0.236 in.) |
| 4. INSTALL FRONT DOOR WINDOW LOWER FRAME |
| 5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH |
| 6. INSTALL FRONT DOOR LOWER FRAME SUB-ASSEMBLY |
| 7. INSTALL FRONT DOOR GLASS RUN |
| 8. INSTALL FRONT DOOR WEATHERSTRIP |
| 9. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY |
![]() |
Engage the 8 claws and install a new front door glass outer weatherstrip.
![]() |
Remove the protective tape.
| 10. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Install the outer rear view mirror with the 3 bolts.
Connect the connector.
| 11. INSTALL FRONT DOOR NO. 2 SERVICE HOLE COVER |
| 12. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
| 13. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL |
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |