Home › BODY › EXTERIOR › FRONT DOOR BLACK OUT TAPE

FRONT DOOR BLACK OUT TAPE > REMOVAL

for Preparation Click here




1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



4. REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER

HINT:
Use the same procedure as for the RH side .



5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    B135564
  1. for Driver Side:

    1. Provisionally install the power window regulator master switch.

  1. for Front Passenger Side:

    1. Provisionally install the power window regulator switch.

  1. Close the door glass.

  1. Disconnect the connector.

  1. Remove the 3 bolts and the outer rear view mirror.

    NOTICE:
    Do not drop or damage the outer rear view mirror when removing the bolts.



6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    B135099E01
  1. Apply protective tape to the front door panel in the area around the front door glass outer weatherstrip.



    B135100E01
  1. Using a moulding remover, disengage the 8 claws and remove the front door glass outer weatherstrip.



7. REMOVE FRONT DOOR WEATHERSTRIP

HINT:
Use the same procedure as for the RH side .



8. REMOVE FRONT DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



9. REMOVE FRONT DOOR LOWER FRAME SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



10. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the RH side .



11. REMOVE FRONT DOOR WINDOW LOWER FRAME

HINT:
Use the same procedure as for the RH side .



12. REMOVE NO. 1 BLACK OUT TAPE


    B135201
  1. Using an infrared light, heat the No. 1 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.



13. REMOVE NO. 3 BLACK OUT TAPE


    B135205
  1. Using an infrared light, heat the No. 3 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.



14. REMOVE NO. 2 BLACK OUT TAPE


    B135203
  1. Using an infrared light, heat the No. 2 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.