Home › BODY › EXTERIOR › ACCESS DOOR BLACK OUT TAPE

ACCESS DOOR BLACK OUT TAPE > REMOVAL

for Preparation Click here


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE ACCESS PANEL REAR WEATHERSTRIP

HINT:
Use the same procedure as for the RH side .



2. REMOVE LAP BELT OUTER ANCHOR COVER

HINT:
Use the same procedure as for the RH side .



3. REMOVE ACCESS DOOR INSIDE HANDLE SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



4. REMOVE CUP HOLDER

HINT:
Use the same procedure as for the RH side .



5. REMOVE ACCESS DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



6. REMOVE CENTER PILLAR UPPER GARNISH

HINT:
Use the same procedure as for the RH side .



7. REMOVE ACCESS DOOR OPENING TRIM

HINT:
Use the same procedure as for the RH side .



8. REMOVE ACCESS PANEL WEATHERSTRIP

HINT:
Use the same procedure as for the RH side .



9. REMOVE ACCESS DOOR GLASS OUTER WEATHERSTRIP


    B135103E01
  1. Apply protective tape to the rear door panel in the area around the access door glass outer weatherstrip.



    B135104E01
  1. Using a moulding remover, disengage the 3 clips and remove the access door glass outer weatherstrip.



10. REMOVE ACCESS DOOR GLASS SUB-ASSEMBLY


B139400E01
  1. Apply protective tape to the outer circumference of the rear door glass, as shown in the illustration.

  1. From the interior, insert piano wires between the vehicle body and rear door glass, as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the rear door glass from the vehicle, do not damage the vehicle's paintwork or exterior/interior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the rear door glass.



11. REMOVE NO. 4 BLACK OUT TAPE


    B135194
  1. Using an infrared light, heat the No. 4 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.



12. REMOVE NO. 6 BLACK OUT TAPE


    B135196
  1. Using an infrared light, heat the No. 6 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.



13. REMOVE NO. 5 BLACK OUT TAPE


    B135198
  1. Using an infrared light, heat the No. 6 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.