BACK DOOR LOCK > INSPECTION |
| 1. INSPECT BACK DOOR LOCK |
![]() |
Check the operation of the back door lock actuator.
Apply battery voltage to the back door lock actuator and check the operation of the back door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1 | Unlocks |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 | Locks |
Check the resistance of the door lock and unlock switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Door Lock Condition | Specified Condition |
| 4 - 5 | Unlocked | Below 1 Ω |
| 4 - 5 | Locked | 10 kΩ or higher |
| 4 - 6 | Unlocked | 10 kΩ or higher |
| 4 - 6 | Locked | Below 1 Ω |
| 2. INSPECT BACK DOOR LOCK CYLINDER |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals when the cylinder is operated with a key.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Locked | Below 1 Ω |
| 1 - 2 | Unlocked | 10 kΩ or higher |
| 1 - 3 | Locked | 10 kΩ or higher |
| 1 - 3 | Unlocked | Below 1 Ω |