Home › BODY ELECTRICAL › DOOR LOCK › BACK DOOR LOCK

BACK DOOR LOCK > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE BACK DOOR TRIM COVER RH


B139381
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.



3. REMOVE BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as for the RH side.



4. REMOVE DOOR TRIM RETAINER CAP


B135553
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door trim retainer cap.



5. REMOVE BACK DOOR TRIM BOARD


B135554
  1. Remove the 2 screws.

  1. Disengage the 16 clips and remove the back door trim board.



6. REMOVE BACK DOOR SERVICE HOLE COVER


B135544
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.



7. REMOVE BACK DOOR LOCK


    B135517
  1. Disconnect the back door lock rod as shown in the illustration.

  1. Disconnect the connector.



    B135519E01
  1. Loosen bolt A.

  1. Using "Torx" socket wrench T30, remove the 3 screws and the back door lock.

    NOTICE:
    Do not drop or damage the back door lock when removing the screws.

    HINT:
    Remove the back door lock through the service hole.



8. REMOVE BACK DOOR LOCK CYLINDER


    B135546
  1. Disconnect the connector and the 2 clamps, then remove the retainer.



    B135548
  1. Remove the back door lock cylinder.