Home › BODY › WINDSHIELD / WINDOWGLASS › BACK WINDOW LOCK

BACK WINDOW LOCK > INSTALLATION

for Preparation Click here



1. INSTALL BACK WINDOW LOCK


    B135521
  1. Install the back window lock with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the connector and clamp.



2. INSTALL BACK DOOR SERVICE HOLE COVER


    B135595
  1. Apply butyl tape to the door panel, then install the new back door service hole cover as shown in the illustration.

    HINT:
    1. When installing the service hole cover, pull the links and connectors out through the service hole.
    2. There should be no wrinkles or folds after attaching the service hole cover.
    3. After attaching the service hole cover, check the quality of the seal.



3. INSTALL BACK DOOR TRIM BOARD


    B135554
  1. Engage the 16 clips and install the back door trim board.

  1. Install the 2 screws.



4. INSTALL DOOR TRIM RETAINER CAP


    B135553
  1. Engage the 2 claws and install the door trim retainer cap.



5. INSTALL BACK DOOR TRIM COVER RH


B139382
  1. Engage the 3 claws and back door trim cover.



6. INSTALL BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as for the RH side.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }