Home › BODY › WINDSHIELD / WINDOWGLASS › BACK WINDOW LOCK

BACK WINDOW LOCK > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE BACK DOOR TRIM COVER RH


B139381
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.



3. REMOVE BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as for the RH side.



4. REMOVE DOOR TRIM RETAINER CAP


B135553
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door trim retainer cap.



5. REMOVE BACK DOOR TRIM BOARD


B135554
  1. Remove the 2 screws.

  1. Disengage the 16 clips and remove the back door trim board.



6. REMOVE BACK DOOR SERVICE HOLE COVER


B135544
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.



7. REMOVE BACK WINDOW LOCK


    B135521
  1. Disconnect the connector and clamp.

  1. Remove the 3 bolts and the back window lock.