Home › ENGINE › 1GR-FE EMISSION CONTROL › CANISTER

CANISTER > INSTALLATION

for Preparation Click here



1. INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY


A288062
  1. Engage the 2 claws to install a new leak detection pump sub-assembly to the canister.

    NOTICE:
    1. Do not allow foreign matter such as grease, oil or water to adhere to the O-rings.
    2. Ensure that the claws are engaged properly.



2. INSTALL CHARCOAL CANISTER ASSEMBLY
  1. Install the fuel hose to the charcoal canister assembly with the hose clip.

  1. Install the charcoal canister assembly to the vehicle with the 3 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the fuel hose to the No. 1 charcoal canister tube with the hose clip.

  1. Engage the wire harness clamp, and install the wire harness to the charcoal canister bracket.

  1. Connect the leak detection pump sub-assembly connector.



    A288098E01
  1. Connect the No. 2 canister outlet hose sub-assembly to the charcoal canister assembly.

    1. Align the No. 2 canister outlet hose sub-assembly connector with the charcoal canister assembly, then push in the No. 2 canister outlet hose sub-assembly until the retainer makes a "click" sound to connect the No. 2 canister outlet hose sub-assembly to the charcoal canister assembly.
      Text in Illustration 
      *1
      Nylon Tube
      *2
      O-ring
      *3
      No. 2 Canister Outlet Hose Sub-assembly Retainer
      V100135
      Push

      NOTICE:
      1. Check that there are no scratches or foreign objects on the disconnected parts of the No. 2 canister outlet hose sub-assembly and charcoal canister assembly before performing the work.
      2. After connecting the No. 2 canister outlet hose sub-assembly, check that the No. 2 canister outlet hose sub-assembly is securely connected by pulling the quick connector.



    A288099E01
  1. Connect the fuel tank vent hose to the charcoal canister assembly.

    1. Align the fuel tank vent hose connector with the charcoal canister assembly, then push in the fuel tank vent hose until the retainer makes a "click" sound to connect the fuel tank vent hose to the charcoal canister assembly.
      Text in Illustration 
      *1
      Nylon Tube
      *2
      O-ring
      *3
      Fuel Tank Vent Hose Retainer
      V100135
      Push

      NOTICE:
      1. Check that there are no scratches or foreign objects on the disconnected parts of the fuel tank vent hose and charcoal canister assembly before performing the work.
      2. After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling the quick connector.



3. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed / ON.

  1. Check fuel pump operation.

    1. Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
      If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.