FUEL PUMP > DISASSEMBLY |

| 1. REMOVE FUEL SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the fuel sender gauge connector.
![]() |
Press down on the fuel sender gauge claw labeled A. Then slide the fuel sender gauge upward to remove it.
![]() | Press Down |
![]() | Slide |
| 2. REMOVE NO. 1 FUEL SUB-TANK |
![]() |
Disconnect the fuel pump connector.
![]() |
Disconnect the jet pump from the No. 1 fuel sub-tank.
| *1 | Jet Pump |
| *2 | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw from the No. 1 fuel sub-tank.
![]() |
Disengage the 3 claws.
![]() |
Disengage the 3 claws and remove the No. 1 fuel sub-tank.
| 3. REMOVE FUEL PUMP |
![]() |
Disengage the 5 claws and separate the fuel pump from the fuel filter case.
| *1 | Fuel Filter Case |
Disconnect the fuel pump wire harness connector from the fuel pump to remove it.
![]() |
Remove the O-ring and fuel pump spacer from the fuel pump.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| 4. REMOVE FUEL MAIN VALVE ASSEMBLY |
![]() |
Remove the fuel main valve from the fuel filter case.
| *1 | Fuel Filter Case |
| *2 | O-ring |
Remove the 2 O-rings from the fuel main valve.