Home › ENGINE › 1GR-FE FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FUEL MAIN VALVE ASSEMBLY


    A223172E02
  1. Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve.
    Text in Illustration 
    *1
    New O-ring

  1. Install the fuel main valve to the fuel filter case.

    NOTICE:
    Make sure the O-rings are not cut or pinched during the installation.



2. INSTALL FUEL PUMP


    A223260E02
  1. Connect the fuel pump wire harness connector to the fuel pump.
    Text in Illustration 
    *1
    New O-ring
    *2
    Fuel Pump Spacer

  1. Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump.



    A223259E01
  1. Engage the 5 claws and install the fuel pump onto the fuel filter case.
    Text in Illustration 
    *1
    Fuel Filter Case

    HINT:
    Perform "Inspection After Repairs" after replacing the fuel pump (Click here).



3. INSTALL NO. 1 FUEL SUB-TANK


    A223171
  1. Engage the 3 claws.



    A223170
  1. Engage the 3 claws and install the No. 1 fuel sub-tank.



    A223268E02
  1. Install the tube part to the No. 1 fuel sub-tank.
    Text in Illustration 
    *1
    Jet Pump

  1. Connect the jet pump to the No. 1 fuel sub-tank.

  1. Connect the fuel pump connector.



4. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A223133E01
  1. Set the fuel sender gauge to the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.