Home › ENGINE › 1GR-FE COOLING › FAN

FAN > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER


    A229925E02
  1. Raise the front of the V-bank cover to disengage the 2 pins.
    Text in Illustration 
    *1
    Pin
    *2
    Hook
    *3
    No. 1 V-bank Cover Bracket

  1. Disengage the 2 hooks and remove the V-bank cover from the No. 1 V-bank cover bracket.



2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts from the No. 1 engine under cover sub-assembly.



    A224743E01
  1. Unhook the No. 1 engine under cover sub-assembly from the frame as shown in the illustration.
    Text in Illustration 
    *a
    Hook
    *b
    Frame



3. REMOVE UPPER RADIATOR SUPPORT SEAL


    A226630
  1. Disengage the 7 clips and remove the upper radiator support seal from the fan shroud.



4. REMOVE FAN SHROUD


    A289174
  1. Disconnect the radiator reserve tank hose from the radiator assembly.



    A226632
  1. Loosen the 4 nuts holding the fan and fluid coupling assembly.



    A217571
  1. While turning the V-ribbed belt tensioner assembly counterclockwise, align the service hole for the V-ribbed belt tensioner assembly and the V-ribbed belt tensioner assembly fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the V-ribbed belt tensioner assembly in place.

    HINT:
    The pulley bolt for the V-ribbed belt tensioner assembly has a left-hand thread.

  1. Remove the fan and generator V belt.



    A287966E01
  1. Disengage the clamp and disconnect the 2 oil cooler hoses from the hose clamp.
    Text in Illustration 
    *1
    Oil Cooler Hose

  1. Remove the bolt and separate the radiator reserve tank assembly from the radiator assembly.

  1. Remove the 2 bolts and separate the fan shroud from the radiator assembly.

  1. Disengage the 2 guides of the fan shroud from the radiator assembly as shown in the illustration.

  1. Remove the 4 nuts of the fan and fluid coupling assembly, and then remove the fan shroud together with the fan and fluid coupling assembly.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the engine water pump assembly.



5. REMOVE FAN


A112113
  1. Remove the 4 nuts and the fan from the fluid coupling.