IGNITION SWITCH > INSPECTION |
| 1. INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
| Switch Condition | Tester Connection | Specified Condition |
| LOCK | - | 10 kΩ or higher |
| ACC | 1 (AM1) - 3 (ACC) | Below 1 Ω |
| ON | 1(AM1) - 3 (ACC) - 4 (IG1) 7 (IG2) - 8 (AM2) | Below 1 Ω |
| START | 1 (AM1) - 2 (ST1) - 4 (IG1) 6 (ST2) - 7 (IG2) - 8 (AM2) | Below 1 Ω |