OUTER REAR VIEW MIRROR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT ARMREST BASE UPPER PANEL |
![]() |
Disengage the 3 claws and clip and remove the front armrest base upper panel.
Disconnect the connector.
| 3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
| 4. REMOVE NO. 2 FRONT DOOR SERVICE HOLE COVER |
| 5. REMOVE OUTER REAR VIEW MIRROR |
![]() |
Driver side:
Provisionally install the power window regulator master switch.
Passenger side:
Provisionally install the power window regulator switch.
Close the door glass.
Disconnect the connector.
Remove the 3 bolts and the outer rear view mirror.
![]() |
Apply protective tape to the lower part of the mirror body.
Press down the upper part of the mirror and tilt the mirror.
![]() |
Using a screwdriver with its tip wrapped in protective tape, insert it between the mirror holder and the mirror holder base.
![]() |
Twist and disengage the 2 clips on the lower side of the mirror.
While holding the mirror with the screwdriver, disengage the 4 clips and 2 claws on the upper side of the mirror and remove the mirror.
Driver side:
Remove the power window regulator master switch.
Passenger side:
Remove the power window regulator switch.
| 6. REMOVE OUTER REAR VIEW MIRROR ILLUMINATION LIGHT BULB (w/ Illumination) |
![]() |
Turn the outer rear view mirror illumination light socket and bulb, in the direction indicated by the allow in the illustration, to remove them.
Remove the outer rear view mirror illumination light bulb from the light socket.