Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Back-up Light Circuit

for Preparation Click here


DESCRIPTION

This circuit sends a signal of the back-up light switch or park/neutral position switch to the clearance warning ECU.

WIRING DIAGRAM


B268488E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK TRANSMISSION TYPE
  1. Check the transmission type.
    Result 
    Result
    Proceed to
    Automatic Transmission
    A
    Manual Transmission
    B



B
Go to step 4
A


2.INSPECT PARK/NEUTRAL POSITION SWITCH
  1. Inspect the park/neutral position switch (Click here).



NG
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - CLEARANCE WARNING ECU AND IGNITION SWITCH)
  1. Disconnect the B35 park/neutral position switch connector.

  1. Disconnect the E80 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    B35-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B35-1 (RL) - E80-13 (RL)
    Always
    Below 1 Ω

  1. Reconnect the park/neutral position switch connector.

  1. Reconnect the clearance warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

4.INSPECT BACK-UP LIGHT SWITCH


    B268889E01
  1. Remove the back-up light switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Back-up Light Switch)

  1. Reinstall the back-up light switch.



NG
REPLACE BACK-UP LIGHT SWITCH
OK


5.CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH - CLEARANCE WARNING ECU AND IGNITION SWITCH)
  1. Disconnect the B42 back-up light switch connector.

  1. Disconnect the E80 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    B42-2 - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B42-1 - E80-13 (RL)
    Always
    Below 1 Ω

  1. Reconnect the back-up light switch connector.

  1. Reconnect the clearance warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)