Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF REAR SHOCK ABSORBER


C133059E01
  1. Fully extend the shock absorber piston rod.

  1. Using a drill or similar tool, slowly make a hole in the cylinder as shown in the illustration, and discharge the gas inside.

    NOTICE:
    1. The gas is colorless, odorless and harmless.
    2. Since the discharged gas may cause chips to scatter, cover the drill with a shop rag or piece of cloth when making the hole.