Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > INSTALLATION

for Preparation Click here



1. INSTALL REAR COIL SPRING


D028471
  1. Install the coil spring to the rear axle housing.

    HINT:
    Fit the lower end of the coil spring into the gap of the spring lower seat.



2. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER


D028132
  1. Install the shock absorber and temporarily tighten the bolt.



3. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



4. FULLY TIGHTEN REAR SHOCK ABSORBER


D028132
  1. Fully tighten the bolt.

    Torque:
    98 N*m{ 1,000 kgf*cm , 72 ft.*lbf }



5. INSTALL REAR BRAKE TUBE FLEXIBLE HOSE


D028273E04
  1. Install the 2 flexible hoses with 2 new clips.

  1. Using a union nut wrench, install the 2 brake tubes onto the flexible hose.

    Torque:
    without union nut wrench:
    15 N*m{ 154 kgf*cm , 11 ft.*lbf }
    with union nut wrench:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    NOTICE:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a fulcrum length of 22 mm (0.886 in.) (Click here).
    2. This torque value is effective when union nut wrench is parallel to a torque wrench.



6. BLEED BRAKE LINE
  1. Turn the ignition switch on (IG).

  1. Remove the brake master cylinder reservoir filler cap assembly.

  1. Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.

  1. Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.

  1. Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.

  1. With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.

    HINT:
    1. Air is bled as the pump motor operates while the brake pedal is being depressed.
    2. Be sure to release the brake pedal to stop the motor after approximately 100 seconds of continuous operation.
    3. As brake fluid is continuously drained while the pump operates, it is not necessary to repeatedly depress the brake pedal.

  1. When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.

  1. Turn the ignition switch off (IG).

  1. Inspect for brake fluid leaks.

  1. Check and adjust the brake fluid level .



7. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }