Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. SEPARATE REAR SHOCK ABSORBER
  1. Support the rear axle housing.



    D028132
  1. Remove the bolt and separate the shock absorber.



3. SEPARATE REAR BRAKE TUBE FLEXIBLE HOSE


D028273E04
  1. Using a union nut wrench, separate the 2 brake tubes.

    HINT:
    Use a container to catch the brake fluid.

  1. Remove the 2 clips and disconnect the 2 flexible hoses.



4. REMOVE REAR COIL SPRING
  1. Start to lower the rear axle housing.

    NOTICE:
    Do not snap the brake line or the parking brake cable.

  1. While lowering the rear axle housing, remove the coil spring.