Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL REAR STABILIZER BUSH


D028261E01
  1. Install the 2 stabilizer bushes onto the stabilizer bar.

    HINT:
    Install the stabilizer bush onto the outer side of the bush stopper on the stabilizer bar.



2. INSTALL REAR STABILIZER BAR


D028260
  1. Install the stabilizer bar and 2 stabilizer bracket covers with the 4 bolts.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }



3. INSTALL REAR STABILIZER LINK ASSEMBLY


D028258
  1. Install the stabilizer link with the nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

  1. Install the 2 No. 1 retainers, 2 cushions and No. 2 retainer.



    D028259
  1. While holding the stabilizer link with a wrench, install a new nut.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

  1. The installation procedure for the RH side is the same as that for the LH side.



4. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }