Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR STABILIZER LINK ASSEMBLY


D028258
  1. Remove the nut and separate the stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



    D028259
  1. While holding the stabilizer link with a wrench, remove the nut.

  1. Remove the 2 No. 1 retainers, 2 cushions, No. 2 retainer and stabilizer link.

  1. The removal procedure for the RH side is the same as that for the LH side.



3. REMOVE REAR STABILIZER BAR


D028260
  1. Remove the 4 bolts, stabilizer bracket cover and stabilizer bar.



4. REMOVE REAR STABILIZER BUSH
  1. Remove the stabilizer bush from the stabilizer bar.