Home › DRIVE LINE ยท PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY

FRONT PROPELLER SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY
  1. Check that the propeller shaft is not damaged or deformed.
    If necessary, replace the propeller shaft.



    C029928
  1. Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    0.3 mm (0.012 in.)

    If the shaft runout is greater than the maximum, replace the propeller shaft.



2. INSPECT UNIVERSAL JOINT SPIDER BEARING
  1. Check that the joints move smoothly.

  1. Check the spider bearings for wear and damage.

  1. Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0 mm (0 in.)

    If necessary, replace the spider bearing.



3. REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER KIT


    F015023E04
  1. Place matchmarks on the flange yoke and sleeve yoke.



    C061264
  1. Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.



    F015025E05
  1. Using SST, push out the spider bearing from the propeller shaft.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.



    F044192E02
  1. Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

    NOTICE:
    Do not tap the shaft.

    HINT:
    Remove the bearing on the opposite side in the same procedure.



    F015030E04
  1. Install the 2 removed spider bearing outer races onto the spider.

  1. Using SST, push the bearing out of the yoke.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.



    F044193E03
  1. Clamp the outer bearing race in a vise and tap off the flange yoke with a hammer.

  1. Remove the spider.