EXTENSION HOUSING OIL SEAL > INSTALLATION |
| 1. INSTALL TRANSFER EXTENSION HOUSING OIL SEAL |
Coat the lip of a new oil seal with MP grease.
![]() |
Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.
| 2. INSTALL TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL (for Rear) |
Using SST and a hammer, tap in a new oil seal (for rear) in the same way as the oil seal (for front).
| 3. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY |
Apply gear oil to the connecting areas of the companion flange and output shaft.
Using SST, install the companion flange (rear) in the same way as the companion flange (front).
| 4. INSTALL REAR PROPELLER SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Install the propeller shaft assembly with the 4 bolts, 4 nuts and 4 washers.
![]() |
Align the matchmarks on the propeller shaft flange and transfer flange.
Install the propeller shaft assembly with the 4 nuts and 4 washers.
| 5. INSTALL LOWER TRANSFER CASE PROTECTOR |
Install the protector with the 4 bolts.
| 6. ADD TRANSFER OIL |
Remove the case plug (for filler) and gasket.
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket and the case plug (for filler).
| 7. CHECK FOR TRANSFER OIL LEAKAGE |
Remove the case plug (for filler) and gasket.
![]() |
Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
If the result is not as specified, add transfer oil.
When the oil level is too low, check for oil leakage.
Install a new gasket into the case plug (for filler) and then tighten the plug.