FRONT DIFFERENTIAL CARRIER OIL SEAL > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts from the No. 1 engine under cover sub-assembly.
![]() |
Unhook the No. 1 engine under cover sub-assembly from the frame as shown in the illustration.
| *a | Hook |
| *b | Frame |
| 2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY |
Remove the 4 bolts, then remove the rear engine under cover.
| 3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4bolts and 4 washers.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts, 4 washers and the propeller shaft assembly.
| 4. REMOVE FRONT DRIVE PINION COMPANION FLANGE NUT |
![]() |
Using SST and a hammer, loosen the staked part of the nut.
![]() |
Using SST to hold the companion flange, remove the nut.
| 5. REMOVE FRONT DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Using SST, remove the companion flange.
| 6. REMOVE FRONT DIFFERENTIAL CARRIER OIL SEAL |
![]() |
Using SST, remove the oil seal.
| 7. REMOVE FRONT DIFFERENTIAL DRIVE PINION OIL SLINGER |
| 8. REMOVE FRONT DRIVE PINION REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the roller bearing (inner).
![]() |
Using SST, tap out the roller bearing (outer).
| 9. REMOVE FRONT DIFFERENTIAL OIL STORAGE RING |
Using a screwdriver and hammer, tap out the oil storage ring.
| 10. REMOVE FRONT DIFFERENTIAL DRIVE PINION BEARING SPACER |