Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE RADIATOR GRILLE


    B134729
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Disengage the 5 clips and remove the radiator grille.



3. REMOVE FRONT BUMPER FILLER


E127192
  1. Disengage the 2 claws and clip and remove the front bumper filler.



4. REMOVE HEADLIGHT ASSEMBLY


E127193E01
  1. Disconnect the 2 connectors.

  1. Remove the 3 screws.

  1. Disengage the clip and pin and slide the headlight toward the front of the vehicle.