Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT GASKET


    E148338
  1. Remove the rear combination light gasket.

    NOTICE:
    1. Detach the combination light gasket if it adheres to the body.
    2. Do not reuse a removed combination light gasket. Replace it with a new one to prevent water from entering.



2. REMOVE TAIL AND STOP LIGHT BULB


    E148339
  1. Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb, in the direction indicated by the arrow in the illustration to remove them.

  1. Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.



3. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    E148345
  1. Detach the 3 clamps to separate the rear combination light socket from the rear combination light.

  1. Disconnect the connector and remove the rear combination light socket and wire sub-assembly from the rear combination light.



4. REMOVE BACK UP LIGHT SOCKET


    E148340
  1. Turn the back up light socket with the back up light bulb, in the direction indicated by the arrow in the illustration to remove them.



5. REMOVE BACK UP LIGHT BULB
  1. Remove the back up light bulb from the back up light socket.



6. REMOVE REAR TURN SIGNAL LIGHT SOCKET


    E148341
  1. Turn the rear turn signal light socket with the rear turn signal light bulb, in the direction indicated by the arrow in the illustration to remove them.



7. REMOVE REAR TURN SIGNAL LIGHT BULB
  1. Remove the rear turn signal light bulb from the rear turn signal light socket.