Home › BODY ELECTRICAL › LIGHTING › REAR DOOR COURTESY SWITCH (for Upper Side)

REAR DOOR COURTESY SWITCH (for Upper Side) > INSTALLATION

for Preparation Click here



1. INSTALL ACCESS PANEL UPPER LOCK ASSEMBLY


B135532
  1. Install the access panel upper lock with the 3 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    B135531
  1. Connect the connector, harness clamp and access panel lock control cable.



2. INSTALL CENTER PILLAR UPPER GARNISH


B135560
  1. Engage the 2 clips and install the center pillar upper garnish.



    B135559
  1. Install the 2 screws.

  1. Install the clip.



3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


B135558
  1. Engage the 9 clips and install the rear door trim board.



    B135526
  1. Install the front seat belt outer (floor side) with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



4. INSTALL NO. 1 CUP HOLDER


B135528
  1. Install the No. 1 cup holder with the screw.



5. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY


B140033
  1. Install the rear door inside handle with the snap ring onto the access panel inside handle.



6. INSTALL LAP BELT OUTER ANCHOR COVER


B135525
  1. Engage the 3 claws and install the lap belt outer anchor cover.



7. INSTALL ACCESS PANEL REAR WEATHERSTRIP


B135524
  1. Install the access panel rear weatherstrip.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }