REAR DOOR COURTESY SWITCH (for Upper Side) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ACCESS PANEL REAR WEATHERSTRIP |
![]() |
Remove the access panel rear weatherstrip.
| 3. REMOVE LAP BELT OUTER ANCHOR COVER |
![]() |
Disengage the 3 claws and remove the lap belt outer anchor cover.
| 4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY |
![]() |
Insert a clip remover between the rear door inside handle sub-assembly and rear door trim board sub-assembly.
Turn the rear door inside handle sub-assembly with the clip remover inserted, as shown in the illustration.
Remove the rear door inside handle sub-assembly and snap ring.
| 5. REMOVE NO. 1 CUP HOLDER |
![]() |
Remove the screw and No. 1 cup holder.
| 6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Disengage the 9 clips and remove the rear door trim board sub-assembly.
| 7. REMOVE CENTER PILLAR UPPER GARNISH |
![]() |
Remove the clip.
Remove the 2 screws.
Disengage the 2 clips.
Pass the floor anchor of the front seat outer belt assembly through the center pillar upper garnish and remove the center pillar upper garnish.
| 8. REMOVE ACCESS PANEL UPPER LOCK ASSEMBLY |
![]() |
Disconnect the connector, harness clamp and the access panel lock control cable.
![]() |
Remove the 3 bolts, then remove the access panel upper lock.