Home › BODY ELECTRICAL › LIGHTING › REAR DOOR COURTESY SWITCH (for Lower Side)

REAR DOOR COURTESY SWITCH (for Lower Side) > INSTALLATION

for Preparation Click here



1. INSTALL ACCESS PANEL LOWER LOCK ASSEMBLY


B135562
  1. Install the access panel lower lock onto the rear door.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



    B135561
  1. Connect the connector, connector clamp and access panel lock control cable.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


B135558
  1. Engage the 9 clips and install the rear door trim board.



    B135526
  1. Install the front seat belt outer (floor side) with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



3. INSTALL NO. 1 CUP HOLDER


B135528
  1. Install the No. 1 cup holder with the screw.



4. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY


B140033
  1. Install the rear door inside handle with the snap ring onto the access panel inside handle.



5. INSTALL LAP BELT OUTER ANCHOR COVER


B135525
  1. Engage the 3 claws and install the lap belt outer anchor cover.



6. INSTALL ACCESS PANEL REAR WEATHERSTRIP


B135524
  1. Install the access panel rear weatherstrip.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }