Home › BODY ELECTRICAL › LIGHTING › REAR DOOR COURTESY SWITCH (for Lower Side)

REAR DOOR COURTESY SWITCH (for Lower Side) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the RH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ACCESS PANEL REAR WEATHERSTRIP


B135524
  1. Remove the access panel rear weatherstrip.



3. REMOVE LAP BELT OUTER ANCHOR COVER


B357293
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY


B135527
  1. Insert a clip remover between the rear door inside handle sub-assembly and rear door trim board sub-assembly.

  1. Turn the rear door inside handle sub-assembly with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door inside handle sub-assembly and snap ring.



5. REMOVE NO. 1 CUP HOLDER


B135528
  1. Remove the screw and No. 1 cup holder.



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B357499
  1. Disengage the 9 clips and remove the rear door trim board sub-assembly.



7. REMOVE ACCESS PANEL LOWER LOCK ASSEMBLY


B135561
  1. Disconnect the connector, connector clamp and access panel lock control cable.



    B135562
  1. Using "Torx" socket wrench T30, remove the 3 screws.

  1. Remove the access panel lower lock by sliding it upward.