Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > INSTALLATION

for Preparation Click here



1. INSTALL PARKING BRAKE SWITCH
  1. Install the parking brake switch with the screw.



2. INSTALL PARKING BRAKE LEVER


D030033
  1. Install the parking brake lever and provisionally tighten the 2 bolts.



    G022567E01
  1. Install the center support and washer onto the parking brake lever.



    D030034
  1. Install the parking brake lever with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Install the straight pin into the parking brake lever.



    G022564E01
  1. Connect parking brake cables No. 2 and No. 3 to the parking brake pull rod.



    G022569
  1. Install the set spring, bush and parking brake pull rod with the adjusting nut.

  1. Connect the parking brake switch connector.



3. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)



4. ADJUST PARKING BRAKE LEVER TRAVEL


G022563
  1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.



5. INSTALL FRONT CONSOLE BOX


    B133851
  1. Engage the 5 claws and install the front console box.

  1. Install the 4 <D> screws.



6. INSTALL BOX BOTTOM MAT


    B133899
  1. Install the box bottom mat.



7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Engage the 3 claws and 5 clips and install the console upper rear panel.



8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133896
  1. Install the shift lever knob.



9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133894
  1. Install the shift lever knob.



10. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133901E01
  1. Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 C claws.

  1. Engage the 4 claws and install the parking brake hole cover.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }