Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133893
  1. Remove the shift lever knob.



4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133895
  1. Remove the shift lever knob.



5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.



6. REMOVE BOX BOTTOM MAT


    B133899
  1. Remove the box bottom mat.



7. REMOVE FRONT CONSOLE BOX


    B133851
  1. Remove the 4 <D> bolts.

  1. Disengage the 5 claws and remove the console box.



8. REMOVE PARKING BRAKE LEVER
  1. Release the parking brake lever.

  1. Disconnect the parking brake switch connector.



    G022563
  1. Remove the adjusting nut.



    G022564E01
  1. Disconnect parking brake cables No. 2 and No. 3 from the parking brake pull rod.

  1. Remove the parking brake pull rod, bush and set spring.

  1. Remove the straight pin from the parking brake lever.



    G022566E01
  1. Remove the washer.

  1. Remove the 2 bolts and center support from the parking brake lever.



    D030033
  1. Remove the 2 bolts and parking brake lever.



9. REMOVE PARKING BRAKE SWITCH
  1. Remove the screw and parking brake switch from the parking brake lever.