Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE REAR WHEEL


2. ADJUST PARKING BRAKE SHOE CLEARANCE


D028131E01
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the disc locks.

  1. Contract the shoe adjuster until the disc rotates smoothly.

    Standard:
    Return 8 notches

  1. Install the hole plug.



3. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }



4. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)



5. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.



6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133893
  1. Remove the shift lever knob.



7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133895
  1. Remove the shift lever knob.



8. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.



9. ADJUST PARKING BRAKE LEVER TRAVEL


G022563
  1. Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    5 to 7 clicks at 200 N (20 kgf, 45 lbf)

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.



10. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Engage the 3 claws and 5 clips and install the console upper rear panel.



11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133896
  1. Install the shift lever knob.



12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133894
  1. Install the shift lever knob.



13. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133901E01
  1. Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 C claws.

  1. Engage the 4 claws and install the parking brake hole cover.