Home › BRAKE › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > REMOVAL

for Preparation Click here



1. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133893
  1. Remove the shift lever knob.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133895
  1. Remove the shift lever knob.



4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.



5. REMOVE BOX BOTTOM MAT


    B133899
  1. Remove the box bottom mat.



6. REMOVE FRONT CONSOLE BOX


    B133851
  1. Remove the 4 <D> bolts.

  1. Disengage the 5 claws and remove the console box.



7. REMOVE REAR WHEEL


8. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


C133098
  1. Remove the 2 bolts and 2 washers and separate the disc brake caliper assembly.

    NOTICE:
    Suspend the disc brake caliper assembly with a piece of rope.



9. REMOVE REAR DISC
  1. Release the parking brake lever.



    D028126E05
  1. Place matchmarks on the disc and axle hub and remove the disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.



10. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING


D028127
  1. Using needle-nose pliers, remove the 2 return tension springs.



11. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and compression spring.



12. REMOVE PARKING BRAKE SHOE


D028128
  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Disconnect the return tension spring and remove the No. 2 shoe.

  1. Remove the shoe adjusting screw set and return tension spring.

  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Using needle-nose pliers, disconnect the parking brake cable and remove the No. 1 shoe.



13. REMOVE PARKING BRAKE CABLE HEAT INSULATOR (for RH Side)


C133095
  1. Remove the 2 bolts and the heat insulator.



14. REMOVE PARKING BRAKE CABLE


G022563
  1. Loosen the adjusting nut.



    D028481E01
  1. Disconnect the cable end from the parking brake pull rod.

  1. Contract the claws of the spring cap and push the parking brake cable slightly out of the vehicle.



    D028121E01
  1. Remove the 2 bolts and separate the parking brake cable from the parking brake plate.



  1. Remove the 5 bolts and the parking brake cable.


    C133096



15. REMOVE PARKING BRAKE CABLE CLAMP
  1. Remove the parking brake cable clamp from the parking brake cable.